Category: DIY

Quick Plumbing Fixes That Can Cost You Money

9/10/2016

by Lyn Lomasi; Owner of Intent-sive Nature & Brand Shamans Content Community

Image in Public Domain

There are certain things you might think are quick that can actually cost you money when it comes to plumbing. Avoid the following quick fixes and call your plumber now before it costs you more later on.

Incorrectly using glue on your sink's p-trap - This is a huge no-no! P-traps need to be changed out at certain intervals and using glue in the wrong section can actually be very bad, as well as toxic. Remember that your water flows through these pipes. Therefore, they should be installed according to the proper city code. If you don't know what that is and don't know how to do it, it's always best to use a local licensed plumber. Otherwise, you could be risking your health and causing a huge cost down the road.

Using duct tape on leaks - While this might seem like a great way to solve an annoying leak, it can actually make it worse. Leaving the water running with an incorrect seal may cause further damage. If you have a leak, cut off the water source immediately and contact a plumber.

Using the wrong caulk or sealant for the project - This might be unhealthy, ineffective, and also a code violation. Please make sure to use the correct sealant or caulk for the project at hand. If you don't know what that is, you shouldn't be doing the job. Remember, some jobs also require a permit and a licensed plumber who has been trained in the code.

Gluing or sealing areas that aren't normally glued or sealed - Certain areas of piping and other plumbing materials should be fit together but not necessarily sealed with glue or other sealants. For instance, as mentioned above, certain sections of the p-trap should be twisted together and never glued for multiple reasons. If there are holes, leaks, or other reasons for a sealant in an unusual place, the plumbing is likely not installed correctly and a licensed plumber should be contacted.

Using the wrong type of pipe for the project - Certain pipes are used for certain projects for a reason. There are specific pipes dedicated to carrying water, gas, and other materials. Not following the correct guidelines can actually be unsafe and against the city's code. Ask your local licensed plumber to get the job done correctly or you could be spending the money more than once if it's done wrong the first time. Also again, certain jobs require a permit and a properly licensed plumber.

Easy, Necessary Fall Home Repairs

10/28/2014

2 Comments

by Lyn Lomasi; Owner of Intent-sive Nature & Brand Shamans Content Community

Image by Kevin Cortopassi via Flickr.com

When the fall season hits, it is time to start preparing your home for the winter and checking for simple repairs that you can do yourself. Doing this will help maintain your home for the coming months, making it a more comfortable and safe environment for you and your family. Here are 10 easy DIY repairs you should do on your home in the fall.

Leaking Kitchen Sinks

If the pipes under your sink are leaking, simply purchase a new PVC p trap and a roll of teflon tape. Removing the old one is as simple as unscrewing the fastened areas and just pulling it off. When installing the new one, place teflon tape at all the joints and screw together the joints. To get the tightest fit, use a plumbing wrench to finish off the screwing. Test your job by running the water for a few minutes. If any water leaks out, either you did not use enough teflon tape or you did not screw the parts together tight enough.

If your sink is leaking around the faucet area, rather than the pipes, you can solve this by replacing the faucet. Simply purchase a new faucet. The instructions for installing your faucet will come in the package. Each can be slightly different. You may also need caulking materials or teflon tape. Check the instructions that come with your faucet.

Bathroom Leaks

Much lie in the kitchen, leaks need to also be addressed in the bathroom. Repairing a leak in a bathroom sin is fairly similar to replacing one in a kitchen. Toilets can also leak. Usually it is due to the ball valve kit located under the back cover. These are about 10 bucks each at a home improvement store. All you need is the kit. It is easy to install and comes with instructions.

Dishwasher

To clean the dishwasher, first start by pulling out all the racks and attachments. Now check all the drains and soap containers for debris. Pull any of that out. Sometimes little pieces of food or glass can get stuck in those, so watch for the glass. Once that is done, check all the rubber sealing and be sure it is all secured properly. If not, adhesive rubber strips can be purchased at home improvement stores. Application is as simple as sticking the strips in the proper spot. The adhesive on these can be strong, so be sure you have it in the proper place before pressing it to the surface.

Part of maintenance also includes cleaning. For this, you'll need vinegar, concentrated lemon juice, baking soda, and a sponge or dishcloth. Sprinkle baking soda along the bottom of the dishwasher. Fill a spray bottle halfway with vinegar, 2 tablespoons of lemon juice, and the rest with water. Spray down the inside of the dishwasher, including the bottom, where the baking soda is. The baking soda will bubble. This is fine. That pulls up dirt and grease. Now starting at the bottom, scrub the entire inside of the dishwasher,m including the door. Do not rinse away the solution. Replace the racks and fill all soap and other liquid dispensers with the lemon juice and vinegar mixture. Close them and run a normal cycle with a hot rinse and heated drying cycle.

Weather Stripping

Check the weather stripping on the interior, as well as the exterior of your home. Replace any worn or peeling areas. Damaged or improperly placed weather stripping can cause cool air to come inside the home, as well as let heat escape. Weather stripping can be purchased at hardware and home improvement stores. There is stripping with adhesive or that which has to be nailed down. Apply according to which type you choose. Be sure the stripping is applied securely to the surface so that it does its job effectively.

Sealing Cracks

Check interior and exterior doors and windows for cracks. Use caulking to seal any detected problem areas. To caulk a crack around a door or window, simply squeeze a line of caulking along the exposed area and swipe it with a caulking sponge to press the sealant in further, as well as to create a smooth finish. Don't forget to also purchase a caulking gun when you buy the caulk. Without one, the caulking is not as easy to apply. A caulking gun can be as low as a few dollars.

Exterior Basement Drains

Some homes can have exterior drains leading to the basement. Be sure to clear away any brush, leaves, dirt, or other debris from the drain openings. Vinegar is a great natural substance that cuts through tough-to-remove dirt and other substances. Simply spray it on from a water bottle, let it sit for a moments, clear away the debris, and wipe the surface clean with a cloth. As for the inside of the drain, run a plumbing snake or auger through the drain. If it is a short drain, a wire coat hanger can sometimes be substituted for the snake or auger if you don't have access to either. Just pull the coat hanger in and out of the drain.

Shut Off Outside Water

The fall season is a great time to shut off the access to any outside water. Doing so can prevent the freezing of the outdoor pipes around hoses and other outdoor water valves. Also, when you do this, unfasten any hoses or other devices attached to outside water valves. These should be stored away until spring.

Carbon Monoxide & Smoke Detectors

This is a good step for more than just the fall season, but be sure you check to see that all of your detection devices are working properly. Most some detectors and carbon monoxide detectors have a test button. Press that button on each to see if they work properly. With increased usage of space heaters, fireplaces, and other heating devices during the fall season, it is important that your family will have working alert devices, should a fire or natural gas problem occur.

Gutters

During the fall, leaves, pine-cones, and other falling debris can get clogged in your gutters. Clogged gutters can lead to poor drainage. To clean out your gutters, simply scoop out the debris that has collected. A garden trowel works well for this. Once that is done, spray the gutters out with a garden hose or pressure washer. If you are using a garden hose, attaching a high pressure spray nozzle will make this easier. If any of the tubular gutters are clogged, use a plumbing snake or auger to unclog them.

Thermostat & Heaters

It is important to be sure your thermostat and heaters are working before he weather starts to get cooler. First, test them by simply turning them on and being sure that the heat is coming out at the right temperature. If there is no heat coming from portable heaters, they should be replaced. If there is no heat coming from the furnace, you will need to test the thermostat.

To do this, first turn off your furnace. Then, return to your thermostat box and remove the cover. Remove the wires from the panel by unscrewing them from it. Take the red and white wire and wrap them together. Tape the wires you won't use to something, such as the wall, while you are working. You don't want to lose them inside the wall. Turn the the furnace back on. If the furnace blows and its burner ignites, then your thermostat is bad. If this doesn't happen, you may actually have a problem with the wires, not the thermostat. Check to make sure the wires run all the way to the furnace.

*I originally published this via Yahoo Contributor Network

2 Comments

Quick Plumbing Fixes That Can Cost You Money

Easy, Necessary Fall Home Repairs

Authors

Archives

Categories